At the same time, this also doesn’t mean that primary compound exercises can never be done for more than 8 reps, or that secondary compound exercise can’t be done for 5-8 or 10-15 reps, or that isolation exercises can’t be done for less than 10 reps. Everything can be done in every rep range. However, these are the rep ranges that each type of exercise is best suited for, and where it should ideally be done most of the time.
This phase continues to employ a four-day split, but bodyparts are paired differently—namely, chest and back are trained on the same day (Day 1), as are biceps and triceps (Day 4). This is little more than a means of changing things up, giving your muscles a slightly different stimulus to spark new muscle growth. Each workout includes drop sets to increase intensity, but for only one set per bodypart, so as to avoid overtraining and muscle catabolism.
Gains will differ from one individual to another depending on body size and level of experience in the gym. To make sure you're gaining muscle, not fat, don't just consider your scale weight. Instead, rely on what you see in the mirror and use a tape measure twice a month to keep track of your waist and hips (you don't want to gain there) as well as your biceps, chest and quads. Also, don't think that you have to gain a set amount of weight each and every week. "Your mass gain doesn't have to be uniform," Aceto explains. That means you can gain 1/2 pound one week and 1 1/2 the next, perhaps none the third week and still remain on course. "Expecting uniform gains ignores the intricate makeup of the body and the way it gains mass - or loses fat - which is by no means in linear fashion," adds Aceto.
From a standing position, balance yourself on your left leg. With your right leg straight and slightly off the floor, perform small circles (from the hip) in front, to the side, and then behind you. Aim for 3-5 circles both clockwise and counterclockwise at each angle. Your supporting leg glutes will be firing to stabilize your pelvis so be sure to stand tall and strong – no swaying.
Make no mistake: Eating for muscle is just as important as lifting for muscle. The foods you grab in the morning on the way to work, the meals you pack for lunch and mid-afternoon, what you put into your body immediately following your workout, and your final meal of the day impact your results as much as, if not more than, the number of reps you squeeze out at the end of a set. But in reality, it can be tough to stick to a "clean" diet when you're busy. We know that adding another layer of complexity to life in the form of reading food labels and studying ingredient lists just isn't an option for most of us. Not to mention actually preparing all those healthy meals.
You can strain or tear one or more of your hip flexors when you make sudden movements such as changing directions while running or kicking. Sports and athletic activities where this is likely to occur include running, football, soccer, martial arts, dancing, and hockey. In everyday life, you can strain a hip flexor when you slip and fall, for example.
I aim to take in 1.5 grams of protein per pound of bodyweight per day and divide that total number by the number of meals I'm going to eat. For me, that means I eat approximately 360 grams of protein each day. I spread this across 6 meals, which turns out to be approximately 60 grams of protein per meal, depending on the day. The reason I eat protein frequently throughout the day is that muscles are built outside the gym. I may spend an hour or two training each day, but it's the other 22 hours or so when I earn my results.
By that logic, a 160-pound man should consume around 160 grams of protein a day—the amount he'd get from an 8-ounce chicken breast, 1 cup of cottage cheese, a roast-beef sandwich, two eggs, a glass of milk, and 2 ounces of peanuts.) If you don't eat meat for ethical or religious reasons, don't worry — you can count on other sources, too. Soy, almonds, lentils, spinach, peas, and beans are packed with protein.
Knowledge – When it comes to building the best physique possible, you have to be willing to experiment and learn from your body. No one will be able to tell you what’s the most effective nutrition or training split for your individual genotype. Not only that, they don’t know your personal preference, injury history, asymmetries, experience level, or current work capacity.
Take note to see if the thigh rests down parallel to the ground (Picture 2) or if it stays up in the air (Picture 1) (You will need someone to be nearby to see what your leg does). Perform on both sides and compare. If the thigh does not stay raised up in the air then there is no true hip flexor tightness and stretching does not need to be performed. If one of the thigh/legs stays up noticeably higher than the other, then stretching will need to be performed. If your leg is able to hang down comfortably parallel to the ground or lower then you passed the test!
Heath suggests incorporating dropsets into your training routine by immediately decreasing the weight and repping out again to failure. “Dropsets overload the muscle with shorter rest periods and increasing volume which you need to grow,” says Heath. “That overload improves your body’s abilities to utilize more nutrients, natural growth hormone, and natural testosterone into those areas and makes the supplements you take more effective.” Heath’s favorite way to do dropsets is on a pin-loaded machine since it’s faster to switch weights.
(6) “Needs to go somewhere” This is where I explain the end of point 3. Insulin is not a fat storage hormone. Insulin simply transports, nutrients, into cells for energy and then stores the nutrients. Protein is not stored, they are recycled, this is why it’s wise to be consistent with protein. Fats are stored as fat. Carbs are stored as glycogen. IF GLYCOGEN is full then insulin will transport the excess glucose to body fat as the glucose needs to go somewhere. It’s not just gonna sit in the blood. If so, this calls for chaos. People that are insulin resistant usually have this chaotic issue.
The iliopsoas muscle is the prime hip flexor and shortening may affect the lower back, pelvis, and/or hip joint. Caution should be taken during this release due to the sensitive area in which the therapist's hand pushes, i.e. proximity to the appendix, possible abdominal aortic abnormalities, potential tissue weaknesses predisposing to inguinal hernias, ovarian conditions, or general irritation/inflammation of the gastrointestinal system; hence, this release may occasionally be replaced by the regular therapeutic stretch presented in Chapter 7 (see Fig. 7.14).
The gluteus maximus can be your best friend when it comes to safely performing backbends. Yet overusing this big muscle by clenching your butt as you backbend can lead to irritation and injury in the spine and sacroiliac (SI) joint. In order to mitigate excessive spinal compression in backbends, it’s helpful to use the buttocks and adductors (inner thighs) to support the weight of the pelvis, hips, and spine. Work on the following actions:
There is no simple orthosis for the management of isolated paralysis of the hip flexor muscles. While the hip guidance and reciprocating gait orthoses mechanically assist hip flexion (see p. 115), neither is prescribed solely for this purpose. Rather they are prescribed for patients with extensive bilateral lower limb paralysis who also require orthotic support around the knees and ankles.
How to do it: Begin with one foot firmly planted in front of you with your other leg extended back. Keep balance by putting your weight in the ball of your front foot and the back heel of your back foot. Hold a dumbbell in either hand, arms at your sides. Or, place a resistance band under the foot of your working leg, up, and around the same shoulder. Stand tall and bend your front working leg to approximately 90 degrees, keeping your knee directly over your ankle so it doesn’t over-extend. Return to the start position and repeat. Do both sides.