Now, while all three are definitely beneficial to the process, I’d consider metabolic stress and muscular damage to be of secondary and tertiary importance, respectively. In addition, they are also things that will pretty much take care of themselves when implementing the workout guidelines and recommendations we’ve already covered (namely for volume, rep ranges, rest periods and exercise selection).
There are many camps within the weight training fitness community. We have bodybuilders, Crossfit athletes, powerlifters, Olympic lifters, and strongman athletes just to name the most popular ones off the top of my head. One thing they all have in common is that they all use resistance to achieve a particular goal. They all also “share” particular exercises. Most resistance-training athletes do barbell squats, overhead presses and deadlifts. I can write pages of differences between each of the disciplines I listed above and I can also write quite a bit about their similarities but one form of resistance training is MORE different than the others. Bodybuilding is the only sport that judges the appearance of the athlete rather than their performance. This may be why bodybuilders tend to get poked at the most.
But as I said earlier, the amount of protein you eat is a secondary concern. Quality comes first, so think "what" before "how much." For me, the "what" is lean and not fried. If you adhere to eating lean, non-fried sources of protein, you maximize your chances of gaining maximum amounts of muscle with minimal increases in body fat. My favorite sources of lean protein are standard: egg whites, chicken breast, 98 percent or leaner ground beef, turkey, fish, and quality protein supplements like Lean Pro8.
Lie on your back with knees bent and feet flat on the floor. Lift your hips to come into a bridge position. Lift your left leg off the ground and extend it in front of you, keeping your pelvis level. Inhale as you slowly lower your hips toward the ground. Exhale as you drive your right heel into the ground and lift your hips. Do 10-12 reps. Switch sides.
Bodybuilders often split their food intake for the day into 5 to 7 meals of roughly equal nutritional content and attempt to eat at regular intervals (e.g. every 2 to 3 hours). This method can serve two purposes: to limit overindulging in the cutting phase, and to physically allow for the consumption of large volumes of food during the bulking phase. Contrary to popular belief, eating more frequently does not increase basal metabolic rate when compared to the traditional 3 meals a day. While food does have a metabolic cost to digest, absorb, and store, called the thermic effect of food, it depends on the quantity and type of food, not how the food is spread across the meals of the day. Well-controlled studies using whole-body calorimetry and doubly labeled water have demonstrated that there is no metabolic advantage to eating more frequently.
Unfortunately, some people are intolerant to milk, due to the casein (one of the proteins in dairy) and have trouble digesting the sugar in milk, called lactose. If this is the case, stick to whey-only protein shakes. Maximuscle uses Biomax Whey True Protein - a unique blend of whey proteins including whey protein concentrate, isolate and hydrolysate, which are lower in lactose. Biomax Whey True Protein is used in a number of Maximuscle products (Promax and Cyclone).
When it comes to training, I prefer to stick with the basics. People think they need 10 different exercises to fashion a fine pair of cheeks, but that's not what it takes. When it comes to toning your glutes, you only need two things: drive and dedication—and I mean real dedication. You must train your glutes hard and diligently to get a great response. If you stop every time it gets difficult or whenever it burns, you're not going to get anywhere.
If you’re new to training, then check out some of the options found on the site and run them exactly as the author intended them to be executed. Too many young guns want to alter every training variable rather than running the program as written and focusing on getting stronger. No, you don’t need an entire day dedicated to arms when you can’t even complete a single chin-up.
So much that they are not truly fasting during sleep anymore. People consume more energy than their body requires…don’t you think this will effect sleep? Sleep cycles? Sleep metabolism? Yes, it will. So people fast during the day and cause chaos for the body, mind, and soul. Why? Because you shouldn’t be fasting during the day, you should be organized with your calories and allow fasting to happen “naturally”.
Overtraining occurs when a bodybuilder has trained to the point where his workload exceeds his recovery capacity. There are many reasons why overtraining occurs, including lack of adequate nutrition, lack of recovery time between workouts, insufficient sleep, and training at a high intensity for too long (a lack of splitting apart workouts). Training at a high intensity too frequently also stimulates the central nervous system (CNS) and can result in a hyperadrenergic state that interferes with sleep patterns. To avoid overtraining, intense frequent training must be met with at least an equal amount of purposeful recovery. Timely provision of carbohydrates, proteins, and various micronutrients such as vitamins, minerals, phytochemicals, even nutritional supplements are acutely critical. A mental disorder informally called “bigorexia” (by analogy with anorexia) may be held accountable of some people overtraining. Sufferers feel as if they are never big enough or muscular enough, which forces them to overtrain in order to try and reach their goal physique.
Protein do not have a home really. They do have a pool on which amino acids are stored, but this isn’t much. Proteins home is actually our muscles. You know how we eat meat for protein? Well if we ate human meat, it would be protein. Muscle is protein. We eat protein to build muscle and other shit. Protein during a calorie surplus will get stored in our fat cells more than go towards building muscle or the pool. Anything eaten in a calorie surplus will be stored as fat.
I say make the 5th rep hard, but when I lift heavy, I like to stick with 4–5 reps. I feel if something is truly heavy, we won’t be able to hold onto it for as long, therefore, 4–5reps is my time frame for failure when lifting heavy. Again, if I need to keep doing reps to reach failure, then it’s too light. When I lift light, my time frame for failure is around 12–15 reps. If I need to do more reps to feel the fatigue of failure, then it’s way too light.
If you have been training properly for at least three years, you’ll find that advanced pump-enhancing techniques like rest-pause sets, drop sets, and some of the other old-school bodybuilding techniques you’ve no doubt heard of can be effective when used sparingly. Just be sure not to overdo the use of them. And never get away from the most important rule: setting PR’s to get stronger.
A: Depending upon your experience level, preference, recovery capacity, and time available, you’ll likely find that 3-5 strength training sessions per week is the sweet spot. If you’re just getting started with weight training, then you should stick with 3 days per week and work your way up. Novices and early intermediates can handle 4 days per week with a split such as an upper lower and seasoned intermediate lifters may be able to handle 5 sessions per week depending upon the programming, recovery, and nutrition strategies that are in place.
Contrary to certain rumors that animal-based protein is more suitable to trigger muscle growth than plant-based protein, a study by Mangano et al. (2017) could not provide any evidence for this. In contrast, if combined properly, plant-based protein can even have a higher biological quality. A combination of one part wheat protein (e.g. seitan) and two parts soy protein (e.g. tofu) has thus been favored by many bodybuilders. Some bodybuilders, such as Patrik Baboumian and Robert Cheeke, follow a strict vegan diet.
How to do it: Balance on your right foot, keeping your midsection tight and shoulders back and down. Bend at the waist with both of your hands out to the sides and extend your left leg back as you fire the left glute. Your shoulder and heel should move together, forming a straight line. Return to starting position and switch legs, performing a set of 10 on each leg.
How to do it: Lie on your back with your feet planted firmly on the floor, knees bent. If you’re just starting and using your bodyweight, reach your arms straight up over your chest and clasp your hands. If you’re using dumbbells, place the weight (plate, kettlebell, dumbbells) comfortably on your pelvis and hold it steady. To really activate your glutes, thrust your hips up toward the ceiling, driving with your legs, and dig your heels into the floor. Lower your hips until they’re hovering right above the floor level, then repeat.
People eat way too many carbs and keep their glycogen levels full for too long. They are always turning sugar into fat because they are always eating carbs. The body wants fats to make fat, not carbs. The body doesn’t even like storing carbs as fat, that’s because we have fat to do that. It’s less stressful to store fat as fat rather carbs as fat. People are stressing themselves out by always eating carbs which always keep their glycogen levels full. They need to carb cycle so that they aren’t gaining fat from BOTH fats and carbs. This is how combining fats and carbs in a meal CAN lead to more fat, only if glycogen is full.
Do standard squats with a weighted bar. Place enough weight on a bar and rack so that it's a little lower than shoulder height. It should be heavy enough that doing a squat is difficult, but not impossible. If you're a beginner, this may mean using a bar without any weight to start with. Duck under the bar and stand up so that the bar rests comfortably on your trapezius muscles, just below the neck. Keep your knees slightly bent and your legs slightly wider than shoulder width. Lift the bar up off the rack and move backwards one step.
Bodybuilders also train small muscles with a similar volume, frequency and intensity of their larger muscles. Strength athletes laugh at this. “Curls are a waste of time” is a common phrase you will hear hurled at a bodybuilder. This is SILLY. Although big compound movements should be most people’s resistance training priority, smaller muscle group focus work has some benefits for every athlete. Bicep tears are quite common among strength athletes, especially strong men and powerlifters. This happens because these competitors will lift tremendous weights with their backs, but their biceps are the weak link. Many of these injuries could be prevented with some good old-fashioned bodybuilder type isolation work. If you are only as strong as your weak link, doesn’t it make sense to make those weak links strong ones?
How to do it: Lie flat on your back with your feet firmly planted on the floor, knees bent, as if you’re doing a standard bridge. Keeping one foot fixed to the ground, lift the other up, keeping the bend in your knee. Drive your hips up toward the ceiling, driving through your planted leg and using the raised leg to keep your pelvis even and balanced. Don’t let your non-working leg/side drop, Reames advises, and keep emphasizing the heel plant. Lower toward the ground, then repeat.
Hip flexors. These hardworking muscles are crucial in foundational movements such as sitting, standing, walking and running — they act as a bridge connecting your torso to your lower body. Some muscles in this group can be notoriously weak or tight and those of you who have ever had issues with this part of your body will know the uncomfortable pain of either all too well. There’s a lot of debate in the world of sports science over how much you should strengthen and stretch your hip flexors — we’ll explain.
The primary hip flexors are the rectus femoris, iliacus, psoas, iliocapsularis, and sartorius muscles. The rectus femoris muscle has two distinct origins proximally: the direct head and the reflected head. They originate at the AIIS and the anterior acetabular rim (in close proximity to the anterior hip capsule), respectively. The tendinous fibers of the rectus femoris coalesce distally and become confluent with the other quadriceps musculature in the thigh. The quadriceps consists of four distinct muscles: 1) the vastus intermedius; 2) the vastus lateralis; 3) the vastus medialis; and 4) the rectus femoris. The rectus femoris is the only quadriceps muscle that traverses both the hip and the knee joint. The rectus femoris is a powerful hip flexor, but it is largely dependent on the position of the knee and hip to assert its influence. It is most powerful when the knee is flexed, whereas significant power is lost when the knee is extended. The rectus femoris is innervated by the femoral nerve (i.e., the posterior division of L2 to L4).
A: If your goal is the largest accrual of muscle mass possible then there may be some benefit to ingesting nutrients with a period of 30-60 minutes after your workout. Does this have to be a protein shake? No, but ideally it should be a meal lower in fat to enhance the digest rate of nutrients within the gastrointestinal tract. However, if you have just eaten a mixed macronutrient meal pre-workout then you should keep in mind that that meal is still likely digesting so there’s no need to throw down the weights after your last set and rush to your locker to slam a protein shake.