Why less volume for the smaller muscle groups, you ask? Partially because they are smaller, but mostly because they get a ton of indirect volume while training the bigger muscle groups (e.g. your biceps get hit pretty hard while training back, triceps get hit pretty hard while training chest and shoulders, shoulders get hit pretty hard while training chest, etc.).
Stand lunge-length in front of a bench making sure your knee does not extend past your toes. Hold a dumbbell in each hand and rest the top of your left foot on the bench behind you. Lower your body until your rear knee nearly touches the floor and your front thigh is parallel to the floor. Then push through the heel of your front foot to return to standing, keeping the back foot on the bench. Repeat for required reps then switch legs.
When these muscles are under constant tension because of ergonomics and habitual postural positioning, they may become tight and shortened. This can result in pulling forward on the lumbar vertebrae, creating hyperlordosis and causing the pelvis to tilt anteriorly. This is commonly seen in people who maintain a seated position for a prolonged period such as office workers, computer programmers, and others who find themselves sitting at a desk for hours every day. It is important to provide education on proper ergonomics, movement, and self-care to these individuals.
How to do it: In general, your feet should be shoulder-width or slightly wider apart (if you’ve got a bigger frame go wider; if you’re smaller, go closer together), and your feet planted firmly on the floor, driving and emphasizing that heel drive. Stand tall. Depending on your preference or what’s available, hold a dumbbell in each hand (arms down at your sides); position yourself under a barbell with the bar against your traps for a back squat, and just over your chest for a front squat; hold a kettbell or dumbbell at your chest for goblet squats; wrap resistance bands under your feet and around your shoulders; or, use just your bodyweight to perform a basic squat.
Those micro-tears that are such a key factor for muscle-building need rest to rebuild themselves and grow stronger. When do they do that? When you’re asleep! “You have to rest and feed your muscles between workouts or you will tear them down and they will become weaker,” says Olson. “Over time, you run the risk of over-training, which can result in injury, and possibly even more sleep troubles.”
How can the muscle progress just because you held a weight for awhile when you could of held a heavier weight for less time? It won’t. It won’t grow because it’s not receiving new tension. Extending the rep by going slower is great, yes, but this slow must be the actual bar speed and not just slow because you can make it slow. You create actual bar speed by making light weight feel heavy. So lift light weight so that the fibers have to switch when it starts to feel heavy. This will increase your strength compared to just lifting heavier right away or all the time. This will help create an actual tempo with actual weights. Remember my example above about how the overall weight after making light weights feel heavy? This is because your muscles have sensed a level of tension that altered its force production so now you have to lift less, yet work harder. Read that again :) this is growth. This is how muscles sense it needs to grow. If you keep the same weight and never increase the weight, then you keep the same tension. This same tension is not enough to create new tension. Remember when I talked about failure? Well, the point where the fatigue of failure comes into play alters as well. It takes less time. That’s the point. Not much time is needed for growth, just break down the muscle as much as it can to a healthy level and do it again. Keep doing it and keep trying to increase the weight.
Bodybuilders spend years and years of their lives focused on perfecting the human body through proper training and nutrition. You, on the other hand, might not have an interest in the sport of bodybuilding, but do want to know the secrets to six-pack abs, a wide back, and rounded shoulders. And what better place to score the tricks of the trade than from 3-time Mr. Olympia Phil Heath.
Athletes with relative shortening of the hip flexors and accompanying weakness of hip extensors will exhibit decreased hip extension at terminal stance phase or “toe off.” Athletes who lack hip extension may also exhibit related limitation in great toe extension. Often these athletes will show decreased wear under the great toe aspect of their shoe sole and relative increased wear under the more lateral toes. These athletes may also demonstrate increased hip flexion at initial contact or “heel strike” in an effort to make up for the shorter stride length caused by limited hip extension. In patients with knee instability this will contribute to hyperextension or “giving way” of the knee.13
Too much sitting: You probably know it can contribute to serious health problems like obesity and osteoporosis. But did you know it also contributes significantly to back woes, including lower back pain in yoga poses? Fortunately, you can use your yoga practice to offset the effects of a sedentary lifestyle, relieve associated back pain, and set the stage for safe practice of intermediate poses like backbends.
Do Belgian squats (or "single leg squats") with a dumbbell. Hold out in front of your chest a dumbbell using both hands. Standing in front of a bench, lift your right leg back so that it's parallel to the floor and resting comfortably on the bench. Bend into a squat using the left leg, so that the right knee almost hits the floor. Lift and repeat 3 x 8. Repeat using opposite leg.
In the last week leading up to a contest, bodybuilders usually decrease their consumption of water, sodium, and carbohydrates, the former two to alter how water is retained by the body and the latter to reduce glycogen in the muscle. The day before the show, water is removed from the diet, and diuretics may be introduced, while carbohydrate loading is undertaken to increase the size of the muscles through replenishment of their glycogen. The goal is to maximize leanness and increase the visibility of veins, or "vascularity". The muscular definition and vascularity are further enhanced immediately before appearing on stage by darkening the skin through tanning products and applying oils to the skin to increase shine. Some competitors will eat sugar-rich foods to increase the visibility of their veins. A final step, called "pumping", consists in performing exercises with light weights or other kinds of low resistance (for instance two athletes can "pump" each other by holding a towel and pulling in turn), just before the contest, to fill the muscles with blood and further increase their size and density.
Working on gluteal muscle strength (buttock muscles) can be beneficial to reduce hip flexor tightness. Working the glute muscles pulls the hip into extension (the opposite of flexion which is what the hip flexor does) and improves muscle balance at the hip. Increasing the strength of your gluteal muscles can help calm the hip flexor down and reduce the feeling of “tightness”.
Alternately, try King Arthur's Pose: Starting on hands and knees with your feet near a wall, put your right shin straight up the wall and bring your left foot forward so it's under the left knee. Place your hands on your knee and lift your spine straight up while taking your tailbone down. You should feel a strong stretch on the front part of your thigh.
Go: Keeping your feet flat on the floor, squat down so the ball rolls up your back, until your quads are just past parallel to the floor. Hold for a count, then lift just your toes into the air to push through your heels as you rise back to the starting position, rotating your glutes and hams inward. Lower your toes back to the floor before starting the next rep.
Bodybuilders often split their food intake for the day into 5 to 7 meals of roughly equal nutritional content and attempt to eat at regular intervals (e.g. every 2 to 3 hours). This method can serve two purposes: to limit overindulging in the cutting phase, and to physically allow for the consumption of large volumes of food during the bulking phase. Contrary to popular belief, eating more frequently does not increase basal metabolic rate when compared to the traditional 3 meals a day. While food does have a metabolic cost to digest, absorb, and store, called the thermic effect of food, it depends on the quantity and type of food, not how the food is spread across the meals of the day. Well-controlled studies using whole-body calorimetry and doubly labeled water have demonstrated that there is no metabolic advantage to eating more frequently.
A: No. You should ensure that the squat and hinge motor pattern are both emphasized but other variations (front squat, sumo deadlift, safety bar squat, Romanian deadlift) should be included until you can master technique on the more advanced variations. For more information on exercise progressions and regressions see this article: Train Like An Athlete, Look Like a Bodybuilder.
To test the flexibility of the hip flexors, specifically the iliopsoas, the Thomas' test10 is used. The patient lies supine and flexes one hip, pulling one knee to the chest. If a hip flexion contracture is present, the contralateral straight leg will rise off of the table. The modified Thomas' test (Figure 12.11) may be preferred. With this variation, the patient sits at the end of the examination table with the knees flexed to 90 degrees. Next, one knee is pulled tight to the chest. The patient is instructed to lie down while maintaining the knee against the chest. If a hip flexion contracture is present, the contralateral leg will rise off of the table. If a rectus femoris contracture is present, the contralateral knee will extend.
The ASISes are good indicators of the tilt of the pelvis. On the side of the pelvis with the extended hip (the back leg), the iliopsoas will try to pull the pelvis and lumbar spine down and forward into an anterior tilt. To counter this, use your fingers to show the ASISes how to lift up. Hold this posterior tilt as you bend the front knee, keeping the back knee straight and the back heel grounded. Feel the iliopsoas lengthen and visualize the spine lifting out of the pelvis.
Another common reason I see glutes that aren’t working properly is due to injury. Often an injury happens that changes the mechanics and motor programming of a person’s body. This can lead to some muscle groups becoming overactive, while others become underactive (think: compensation). This can alter things for a long time without the person even knowing it.
The lower the rep range (and therefore the higher the intensity and the heavier the weight), the more rest there should be between sets. So most of the time, exercises being done in the 5-8 rep range need longer rest periods than exercises being done in the 8-10 rep range, which need longer rest periods than exercises being done in the 10-15 rep range.
If you’re someone who’s got a good stretching routine down, both before and after a HIIT workout, bike ride or run, odds are the discomfort you feel indicates that there are grounds for more strengthening exercises. It’s important to add that many yogis with extremely flexible hips run into overstretching injuries like hip flexor strains. But, these injuries aren’t just limited to the uber-flexible. Runners, cyclists, and Stairmaster lovers might strain these muscles due to frequent overuse. We’ll share a hip flexor workout below but, first up, some stretches.
Tight hip flexors can also make it harder for your glutes to activate—since they're opposing muscle groups, when one is really tight the other becomes lengthened. When a muscle is more lengthened than it should be, it takes away some of its ability to contract. When your glutes are in this compromised position, it can cause other muscles to do more work than they should, making your workouts less efficient and sometimes, increasing your risk of injury.
Of the three, protein will of course play the most important role in the muscle building process (like calories, it’s one our required “supplies”), although fat and carbs will still be important for other reasons which range from optimizing hormone production (e.g. testosterone, the muscle building hormone) to enhancing training performance and recovery.
If you’ve been training longer than 6–12 months, you can split your workouts into upper- and lower-body days. The most common setup is to train upper body one day and lower the next so that each area gets trained twice in one week. If you train four days per week, you can train upper body on Monday, lower Tuesday, rest Wednesday, and then do upper body again on Thursday, lower body on Friday, and then rest on the weekend.
Prolonged sitting and activities like running or cycling can lead to tight hip flexor muscles and a variety of skeletal imbalances. Think: if you only cycle for exercise, certain muscles in your legs will get stronger (in a lot of cases you overwork these muscles) yet your core and outer hip muscles might get weaker from lack of engagement. So what? Well, these muscle imbalances often lead to skeletal imbalances and injuries down the line. If you have particularly tight hip flexors, your body will start to create an anterior pull on the pelvis (anterior pelvic tilt). You can identify an anterior pelvic tilt if your belly protrudes slightly in the front while your butt sticks out in the back (what some people refer to as “duck butt”).