Actual bar speed has to do with tempo. If we rep a light away until it feels heavy, then we have altered the tempo. The muscle switches from short twitch to fast twitch. This takes time for the muscle to switch, so people lift heavy usually to expedite the fast twitch being used. BUT, going slow on PURPOSE, is not the same as actual bar speed. If you can deliberately slow down a weight, then it’s too light. SIMPLE AS THAT. Going slow is for heavy weights, because heavy weights don’t take long to lift. So one must be going slow because of the weight and not because they think time under tension is key. This means, lift more. How much more? I don’t know, but try a little more. If you can do a little more, then you have progressed.
You don't need to design a fresh plan every three weeks. Scaling up weight and modifying reps are obviously both important for progression, but playing with different set styles will shock your body and keep things interesting. Remember, bodybuilding isn't meant to feel like a chore. Below, we explain eight different types of sets to help you build muscle more efficiently during bodybuilding training.
Most typical bodybuilding programs have way too many sets and reps and use the wrong exercises. However, if you lower the total volume, go heavier, and use compound movements as I’ve outlined above, there is nothing wrong with a body-part split for advanced lifters. In fact, it’s often less stressful to the joints than your average upper/lower split.
Spero Karas, MD, assistant professor of orthopaedics in the division of sports medicine at Emory University, says that testosterone, the male hormone responsible for muscle growth, maxes out between the ages of 16 and 18. It reaches a plateau during the 20s and then begins to decline. As a result, muscle building after the adolescent years can be challenging, he says.
When it comes to building muscle, your body only knows or cares about the tension, fatigue and damage an exercise is generating… not the type of equipment you were using when performing that exercise. It really couldn’t give the slightest crap about that. For this reason, ALL types of exercises and ALL types of equipment are capable of stimulating muscle growth.
Sure, using a more effective workout routine or diet plan will work better/faster than a less effective one. However, even when you’re doing everything just right and you’ve optimized every single major and minor factor to work as quickly and effectively as possible (which I’m going to show you how to do), the simple fact is that you’re still not going to build muscle “fast.”
Yes, genetically some of us put on muscle faster than others, but even then it’s fractions of a degree, not DRASTIC sweeping differences. We tend to get this question from men or women who are so thin and have such fast metabolisms, they probably need to put on 40-50+ pounds of both fat and muscle, before they would ever even think to use the word “too bulky.”
This test measures a participant's ability to stand up from a seated position as many times as possible in a thirty-second period of time. Testing the number of times a person can stand up in a thirty-second period helps assess strength, flexibility, pain, and endurance, which can help determine how far along a person is in rehabilitation, or how much work is still to be done.
As a parting thought, we can’t emphasize enough the importance of consistency and staying focused. Your workouts shouldn’t be two-hour affairs—each visit to the gym needs to be fast-paced and intense. With that as your guide and following the heavy-duty blueprint laid out here, we can’t promise it’ll be easy, but the results should be worth every drop of sweat. Just think, 10 more muscular pounds may be a mere month away.
Generally, you should consume about 20 grams of protein with some carbs shortly after a workout. During the post-workout anabolic window, you’ll also want to limit fats, which can slow the absorption of protein. While there is some recent research that suggests the window may actually extend up to several hours following exercise, there’s no harm in getting nutrients in early as long as you’re sticking to your overall caloric and macronutrient goals.
Those 5-pound dumbbells were a great place to start as a beginner, but if you've been lifting weights for a while, it's time to bump up the weight. “You can use both exercise machines and free weights,” explains Michele Olson, PhD, exercise physiologist, professor of exercise science at Auburn University Montgomery, “but, if you are not lifting heavy enough weight, it doesn’t matter if you are primarily using free weights or machines.” In order to build muscle, you must break down muscle tissue using a weight that is challenging enough to cause micro-tears, which when repaired, form denser, stronger fibers.
Carbohydrates give my working muscles the energy to do their job. Without them, I would feel tired, and my gym sessions would definitely struggle as a result. Just like I approach my protein intake as a way to repair my muscles after training, I aim for the carb "sweet spot" where I can maximize energy and glycogen replenishment. And just like with protein, quality is crucial. My carbs come from high-fiber, high-nutrient foods. I include plenty of sweet potatoes, oatmeal, and brown rice, among others.
Consuming sufficient high-quality protein is essential for building muscle. Current recommendations are to consume a minimum of 0.8g of protein for each kg of body weight, however, this is really only applicable to the average sedentary individual. Current evidence shows that to support muscle development, protein intake is the key, therefore the recommended 0.8g per kg should be increased to 1.5-2.0g of protein per kg of body weight. For an 80 kg individual, that would equate to 120-160 grams of protein per day.
Even when glycogen is full and glucose gets stored as fat. This fat can only make us gain IF we keep it their. And most people don’t exercise which keeps fat unused. Sure, fats directly leads to fat gain, but again that doesn’t make us fat unless we keep it their. Weight gain vs fat gain is different. Fat increases before weight does, then overtime it starts to show that fat makes up most of the weight. Same for people with muscle.
Expert tip: To make it harder, inch yourself close to a wall so your trunk is about a foot away. Bring what would be your “planted” leg on the wall, foot flat against the surface. From here, raise your “non-working leg” up into the air, keeping your knee bent. As you raise up into the glute bridge, you’ll drive your heel against the wall, raising your hips. You can also use a bench. And like the standard bridge, you can up the ante by adding weight.
This exercise is challenging and will certainly be beneficial even without weights. If you can execute perfect form with your body weight, you can make the exercise harder by adding weights to your hands, by stepping on an unstable surface with your front foot (balance disc, foam pad), or you can place your rear leg on an unstable surface such as a physioball. You should be able to comfortably perform 2-3 sets of 10 reps on each leg before advancing this exercise.
Prolonged sitting and activities like running or cycling can lead to tight hip flexor muscles and a variety of skeletal imbalances. Think: if you only cycle for exercise, certain muscles in your legs will get stronger (in a lot of cases you overwork these muscles) yet your core and outer hip muscles might get weaker from lack of engagement. So what? Well, these muscle imbalances often lead to skeletal imbalances and injuries down the line. If you have particularly tight hip flexors, your body will start to create an anterior pull on the pelvis (anterior pelvic tilt). You can identify an anterior pelvic tilt if your belly protrudes slightly in the front while your butt sticks out in the back (what some people refer to as “duck butt”).
Located deep in the front of the hip and connecting the leg, pelvis, and abdomen, the hip flexors— surprise, surprise— flex the hip. But despite being some of the most powerful muscles in our bodies (with a clearly important role), it’s easy to neglect our poor hip flexors— often without even knowing it. It turns out just working at a desk all day (guilty!) can really weaken hip flexors since they tend to shorten up while in a seated position. This tightness disrupts good posture and is a common cause of lower back pain. Weakened hip flexors can also increase the risk of foot, ankle, and knee injuries (especially among runners) Hip muscle weakness and overuse injuries in recreational runners. Niemuth, P.E., Johnson, R.J., Myers, M.J., et al. Rocky Mountain University of Health Professions, Provo, VT. Clinical Journal of Sport Medicine, 2005 Jan; 15 (1): 14-21.. So be sure to get up, stand up every hour or so! And giving the hip flexors some extra attention is not just about injury prevention. Adding power to workouts, working toward greater flexibility, and getting speedier while running is also, as they say, all in the hips The effect of walking speed on muscle function and mechanical energetics. Neptune, R.R., Sasaki, K., and Kautz, S.A. Department of Mechanical Engineering, The University of Texas, Austin, TX. Gait & Posture, 2008 Jul; 28 (1): 135-43..
Reaching failure matters because tension matters. Failure is when the muscle cannot generate anymore force. Which means one applied (worked out) enough tension through the muscle to just want to give up. And guess what? Carrying groceries can do this for some. Why? We are all at different strength levels. So don’t worry about other people and what they can or cannot lift. I say this because FAILURE can be achieved with either light weights or heavy weights.
Getting it is another matter, since this is the spot where women tend to hold the most body fat for the longest time. Thankfully, Kim Oddo, celebrity trainer to the fitness stars, and IFBB figure pro—and mother of three—Cheryl Brown are here to show you how to kick your own ass into the shape you want with 10 butt exercise moves specifically designed to improve your bottom line.
Your questions kinda ties everything together. You are already aware of “nutrient density” which is AWESOME. This is important because I believe one food may be more “healthier” over another due to its “nutrient density”. The other food is still healthy because it still contains nutrients, but the nutrients could be more dense…so this is why I think one food may be “healthier”, while the other just isn’t as “healthy”. It’s not, not healthy.. Make sense?
If your fitness goals are to get strong and build hard, visible muscle, then you’re going to want to train in three phases according to Heath. Strength, conditioning, and a blend of the two that works for you. “If you can get to the gym 4-5 days a week, that would be perfect,” he says. “You can still do chest/tri’s, back/bi’s, legs, shoulders, and make the fifth day a cleanup day, meaning focus on body parts you may be weaker in.” Check out Heath’s guide to finding your best muscle-building routine.
In order to validate your account, please either send an email from your .mil email address or send in a snapshot of your military ID to our customer service help desk. Blacking out rank and or post is acceptable. In either case, please include the civilian email address or whichever email address you have registered with Onnit.com somewhere in the message body so we know which account to verify. Please setup an account with Onnit.com prior to submitting your request.
Most problems with the hip flexors, however, don't originate in a lack of strength but in a lack of flexibility. To understand how these muscles lose their flexibility, imagine someone with a broken arm, her bent elbow encased in a plaster cast. When the cast is removed after six or eight weeks, the soft tissues around the elbow (muscles, tendons, ligaments, and even skin) will have shortened, and the elbow won't straighten out. It will take patient stretching over several weeks to restore the range of motion. Similarly, if the hip is constantly kept in a flexed position—like sitting—for hours every day, day after day, the hip flexors will shorten and shrink, limiting your ability to fully extend (straighten) the hip.