Remember my special answer: here it is… MOUTHTAPERS exist. People out there will tape their mouth closed during sleep so that they can breathe their nose. Even during the day sometimes. Why? Because the nose is directly connected to the diaphragm while the mouth is connected to the chest. Sure, increase chest mobility and your lungs may be able to expand more which will allow more air to be held, BUT HOW CAN YOU HOLD THAT MORE AIR IF YOUR DIAPHRAGM is weak? You won’t. So everything I just talked about must be done through the nose. Notice yourself breathing with your mouth and SWITCH right away. It takes work and energy. How you breathe during the day rolls over to how you breathe during the night.
Most problems with the hip flexors, however, don't originate in a lack of strength but in a lack of flexibility. To understand how these muscles lose their flexibility, imagine someone with a broken arm, her bent elbow encased in a plaster cast. When the cast is removed after six or eight weeks, the soft tissues around the elbow (muscles, tendons, ligaments, and even skin) will have shortened, and the elbow won't straighten out. It will take patient stretching over several weeks to restore the range of motion. Similarly, if the hip is constantly kept in a flexed position—like sitting—for hours every day, day after day, the hip flexors will shorten and shrink, limiting your ability to fully extend (straighten) the hip. 

How to From High Lunge with your left foot in front, stretch your arms 
forward, parallel to your mat and to each other, palms facing one another. 
As you exhale, press the left thighbone back and the left heel actively into the floor; straighten your left leg and lift the back leg to come into Warrior III. Keep your pelvis level as you bend your left knee slightly (shown), then straighten it. Repeat 6–8 times without letting the spine, shoulders, or pelvis change their relationship to one another. If you can’t balance, place your fingers on a wall and allow them to slide up and down as you move. Repeat on the other side.
Prolonged sitting and activities like running or cycling can lead to tight hip flexor muscles and a variety of skeletal imbalances. Think: if you only cycle for exercise, certain muscles in your legs will get stronger (in a lot of cases you overwork these muscles) yet your core and outer hip muscles might get weaker from lack of engagement. So what? Well, these muscle imbalances often lead to skeletal imbalances and injuries down the line. If you have particularly tight hip flexors, your body will start to create an anterior pull on the pelvis (anterior pelvic tilt). You can identify an anterior pelvic tilt if your belly protrudes slightly in the front while your butt sticks out in the back (what some people refer to as “duck butt”).

Most typical bodybuilding programs have way too many sets and reps and use the wrong exercises. However, if you lower the total volume, go heavier, and use compound movements as I’ve outlined above, there is nothing wrong with a body-part split for advanced lifters. In fact, it’s often less stressful to the joints than your average upper/lower split.
The iliopsoas muscle is the prime hip flexor and shortening may affect the lower back, pelvis, and/or hip joint. Caution should be taken during this release due to the sensitive area in which the therapist's hand pushes, i.e. proximity to the appendix, possible abdominal aortic abnormalities, potential tissue weaknesses predisposing to inguinal hernias, ovarian conditions, or general irritation/inflammation of the gastrointestinal system; hence, this release may occasionally be replaced by the regular therapeutic stretch presented in Chapter 7 (see Fig. 7.14).

The majority of your workouts should be comprised of compound exercises. Common examples include squats, deadlifts, lunges, bench presses, rows, pull-ups, lat pull-downs, overhead presses, and so on. Isolation exercises should definitely also be a part of your program, just a smaller part in comparison. Common examples include bicep curls, tricep extensions, chest flies, lateral raises, leg curls, leg extensions, calf raises, and so on.


The hip flexor muscles flex the hip during swing. They are particularly important for initiating swing91 when walking at slow speeds. Without adequate hip flexion during swing, knee flexion is more dependent on hamstring muscle activity.59 Patients with paralysis of the hip flexor muscles attempt to advance the swing leg by either externally rotating the hip and using hip adductor muscles as hip flexors or by circumducting the leg.59,61 The effects of hip flexor muscle paralysis on gait are particularly evident when walking up stairs or slopes, which requires lifting the leg.
References to any non-Onnit entity, product, service, person or source of information in this or any other Communication should not be considered an endorsement, either direct or implied, by the host, presenter or distributor of the Communication. The host(s), presenter(s) and/or distributor(s) of this Communication are not responsible for the content of any non-Onnit internet pages referenced in the Communication. Onnit is not liable or responsible for any advice, course of treatment, diagnosis or any other information or services you chose to follow without consulting a qualified medical professional. Before starting any new diet and/or exercise program, always be sure to check with your qualified medical professional.
How to do it: Begin with one foot firmly planted in front of you with your other leg extended back. Keep balance by putting your weight in the ball of your front foot and the back heel of your back foot. Hold a dumbbell in either hand, arms at your sides. Or, place a resistance band under the foot of your working leg, up, and around the same shoulder. Stand tall and bend your front working leg to approximately 90 degrees, keeping your knee directly over your ankle so it doesn’t over-extend. Return to the start position and repeat. Do both sides.
×