When it comes to building muscle, your body only knows or cares about the tension, fatigue and damage an exercise is generating… not the type of equipment you were using when performing that exercise. It really couldn’t give the slightest crap about that. For this reason, ALL types of exercises and ALL types of equipment are capable of stimulating muscle growth.
Working on gluteal muscle strength (buttock muscles) can be beneficial to reduce hip flexor tightness. Working the glute muscles pulls the hip into extension (the opposite of flexion which is what the hip flexor does) and improves muscle balance at the hip. Increasing the strength of your gluteal muscles can help calm the hip flexor down and reduce the feeling of “tightness”.
From a standing position on your left foot, hinge forward from your hips keeping your back flat and right leg in straight behind it, and core braced. Reach your right hand toward your left foot. Then, engage your glutes and hamstrings on your left leg to drive yourself back up to standing and swing your right knee up and through toward your chest. Stand as tall as possible and hold that end position for 2-3 seconds before repeating. This entire exercise is about “sticking” the knee drive hold at the end, so don’t rush through it. Repeat for required reps, then switch sides.

For the bench press, start with a weight that you can lift comfortably. If you are a beginner, try lifting the bar along with 5lbs or 10lbs on each side. With arms at shoulder-width apart, grab onto the bar and slowly lower the bar until it's at nipple level; push up until your arms are fully extended upwards. Do 8–10 repetitions (reps) like this for three sets (3 x 8), adding additional weight each set. Once you have a few months of practice, slowly increase weight and go down to 6–8 reps per set, aiming to reach muscle failure at the end of the third set.
When you’re planning your high-protein meals, 20 grams of protein is the optimal amount generally accepted for muscle growth. Research has found that the body doesn’t use much more than 20 grams for muscle-building at any one sitting. Around 80 grams of protein per day (or, four meals containing 20-grams of protein each) is about right for most people.

You're more likely to get a hip flexor injury if you've had one in the past, you don't warm up properly before engaging in athletic activity, your muscles are already tight or stiff, or your muscles are weak from being overused. If, while exercising, you try to do too much at once in too short an amount of time, you can also put yourself at risk for a hip flexor injury.
2-4 Minutes Rest: Ideal for “tension exercises,” which includes most primary compound exercises. I personally take 3 minutes for the big stuff, sometimes going into the 3-4 minute range depending on exactly what I’m doing and what I feel like I need at the time. Since making strength gains is the main focus of these exercises, longer rest periods like this will be optimal for making it happen.
Of course, you know what it feels like to have a tight muscle. But tight hips aren't just uncomfortable—they can lead to all sorts of other aches and pains, especially in the lower back. "People focus on the hips and say their hips are tight, but we don't always think about the fact that the lower back connects to our legs at the hip," Charlee Atkins, C.S.C.S., instructor at Soul Annex in New York City and creator of Le Stretch class, tells SELF. Tight hip flexors make it harder for your pelvis to rotate properly, which can cause your lower back to overcompensate, "and this can be a setup for lower-back injury," Teo Mendez, M.D., an orthopedic surgeon at NY Orthopedics who focuses on operative and non-operative management of sports-related injuries, musculoskeletal injuries, and arthritis, tells SELF.
If you're 12 weeks out from a competition, you want to maintain as much muscle as possible while torching fat from every angle. This means low-intensity cardio – high intensity cardio speeds up your metabolism and burns fat very quickly, so you run the risk of burning muscle too, Terry says – either first thing in the morning on an empty stomach, or immediately after your weights session, once you’ve depleted those glycogen levels.
See what I mean? Notice, how I said the “fatigue of failure”. This is because one must interpret their fatigue properly. (1) Some go past failure thinking something magical is going to happen, when only damage will occur. (2) Some feel slight fatigue, aren’t close to failure, and should keep going to enter in the actual sensation that matters: failure. (3) Some are very close to reaching fatigue, but misinterpret the sensation as failure and stop, when they were only moments away from feeling something they never felt before.
Whether you love or hate ‘em, squats are one of the best butt exercises for strengthening your backside. Experts say that if you want to run faster, jump higher and lift heavier, squatting low is the way to go. They might look easy, but prepare to work when you add a barbell, slam ball or heel raise to the mix. These squat variations not only add some power to your jumps and kicks, but they also help improve your knee stability and range of motion. So how low can you go? Try these exercises to find out.
Apply the above concept to your hips. When you sit, your hips are in a "flexed" position. Therefore, the muscles that flex your hips are in a shortened state. You probably spend at least a third of your day sitting down. Think about how much time those hip flexor muscles stay shortened. A lot. Over time, they become tighter and tighter until you look like the old man in the picture. So unless you want to look like that, perform the stretches shown below.

Actual bar speed has to do with tempo. If we rep a light away until it feels heavy, then we have altered the tempo. The muscle switches from short twitch to fast twitch. This takes time for the muscle to switch, so people lift heavy usually to expedite the fast twitch being used. BUT, going slow on PURPOSE, is not the same as actual bar speed. If you can deliberately slow down a weight, then it’s too light. SIMPLE AS THAT. Going slow is for heavy weights, because heavy weights don’t take long to lift. So one must be going slow because of the weight and not because they think time under tension is key. This means, lift more. How much more? I don’t know, but try a little more. If you can do a little more, then you have progressed.
Stand on your right foot and lift your left foot off the ground. Inhale as you step your left foot backward into a lunge, so that your left knee hovers above the ground. Exhale as you drive through your right heel to rise to a single-leg stance, bringing your left leg forward and up to hip height. Do 10-12 reps. Switch sides. Optional: Load this move by holding a kettlebell at your chest or a dumbbell in each hand. 

Stretch your hips. Stretching your hips can help alleviate hip flexor pain and keep it from re-occurring. Perform a standing hip flexor stretch. Stand up straight with your feet flat on the ground and shoulder-width apart. Your knees should be straight but not locked. Stand beside a table or chair for support. Slowly lift the knee of the affected leg off the ground and as high in the air as you can comfortably go. Keep your back straight and tighten your hip muscles as you perform this stretch. Hold this position for a count of 2 seconds. Relax and repeat 10 times, twice a day.

Build an effective exercise routine. A good diet is required for your body to be able to maximize your potential, but there's no potential at all until you start the process of tearing down your old muscles and rebuilding them bigger, bulkier, and stronger. The best way to do that is to start at the beginning. If you're not sure where to begin, find a solid workout program online and try it out for a while. Don't immediately jump from one program to the next - you'll end up keeping yourself from making steady progress.


I fortunately remember the nutrition label for many foods. If it doesn’t have a label, I remember what I’ve studied. It just sticks mentally and saves me time as I don’t have to input my calories via tracking. I use to track calories (started like 5yrs ago) which did help me get a better understanding (started to remember within 6m) of which foods had what and at what amount.
Often people try to correct a forward tilt of the pelvis by gripping with the abdominal muscles. But besides limiting your breathing and being counterproductive in backbends, gripping the abdominals won't control the anterior pelvic tilt if you have tight hip flexors—not even in simple standing postures. That's why it's so important to make hip flexor stretches part of your daily practice, especially after a long day of sitting. These poses will let you enjoy a new sense of space in your pelvis—and help protect you from compression and pain in your lower back.
Bodybuilders often split their food intake for the day into 5 to 7 meals of roughly equal nutritional content and attempt to eat at regular intervals (e.g. every 2 to 3 hours). This method can serve two purposes: to limit overindulging in the cutting phase, and to physically allow for the consumption of large volumes of food during the bulking phase. Contrary to popular belief, eating more frequently does not increase basal metabolic rate when compared to the traditional 3 meals a day. While food does have a metabolic cost to digest, absorb, and store, called the thermic effect of food, it depends on the quantity and type of food, not how the food is spread across the meals of the day. Well-controlled studies using whole-body calorimetry and doubly labeled water have demonstrated that there is no metabolic advantage to eating more frequently.[38][39][40]
In the last week leading up to a contest, bodybuilders usually decrease their consumption of water, sodium, and carbohydrates, the former two to alter how water is retained by the body and the latter to reduce glycogen in the muscle. The day before the show, water is removed from the diet, and diuretics may be introduced, while carbohydrate loading is undertaken to increase the size of the muscles through replenishment of their glycogen. The goal is to maximize leanness and increase the visibility of veins, or "vascularity". The muscular definition and vascularity are further enhanced immediately before appearing on stage by darkening the skin through tanning products and applying oils to the skin to increase shine. Some competitors will eat sugar-rich foods to increase the visibility of their veins. A final step, called "pumping", consists in performing exercises with light weights or other kinds of low resistance (for instance two athletes can "pump" each other by holding a towel and pulling in turn), just before the contest, to fill the muscles with blood and further increase their size and density.
We don't allow self-promotional posts. Don't post about athletes outside of the bodybuilding realm. Check the rules to see if your post would belong in one of our bot-automated threads rather than as a separate post. Do not ask for advice on how to rehab an injury or how to deal with any medical condition. Don't post about supplements. If you haven't been training as a bodybuilder for at least a few years, your questions probably belong in the weekly Newbie Tuesdays thread.
Preparation – If you have physique or aesthetic goals then you’re going to have monitor your nutrition. That being said, it will require a bit of work to prepare some healthy meals and ensuring you’re getting enough calories. Not only that, you must approach training in the same way. If you don’t have your gym bag essentials prepped, you’ll end up wasting time looking for your belt and wrist wraps which should already be packed.
A: First, you have to realize that when one is gaining weight it’s nearly impossible (steroid discussion aside) to gain solely muscle without the acquisition of some body fat as well. That being said though, you can improve thedistribution of lean body mass to fat mass by ensuring that your calorie consumption isn’t too aggressive (i.e. 1000+ over your BMR). Also, it should go without saying, but you need to be training hard while focusing on progressive overload to ensure that the calories you’re ingesting are actually going towards muscle growth. You shouldn’t be neglecting cardiovascular work either; both HIIT and LISS each play a role in enhancing mitochondrial density, balancing neurotransmitters, improving oxidative capacity, and influencing brain plasticity.

When these muscles are under constant tension because of ergonomics and habitual postural positioning, they may become tight and shortened. This can result in pulling forward on the lumbar vertebrae, creating hyperlordosis and causing the pelvis to tilt anteriorly. This is commonly seen in people who maintain a seated position for a prolonged period such as office workers, computer programmers, and others who find themselves sitting at a desk for hours every day. It is important to provide education on proper ergonomics, movement, and self-care to these individuals.


Another common reason I see glutes that aren’t working properly is due to injury. Often an injury happens that changes the mechanics and motor programming of a person’s body. This can lead to some muscle groups becoming overactive, while others become underactive (think: compensation). This can alter things for a long time without the person even knowing it. 
×