Go: Keeping your feet flat on the floor, squat down so the ball rolls up your back, until your quads are just past parallel to the floor. Hold for a count, then lift just your toes into the air to push through your heels as you rise back to the starting position, rotating your glutes and hams inward. Lower your toes back to the floor before starting the next rep.
Jason Ferruggia is a highly sought after, world renowned strength & conditioning specialist and muscle building expert. Over the last 17 years he has personally trained more than 700 athletes from over 90 different NCAA, NFL, NHL and MLB organizations. He has also worked extensively with firefighters, police officers, military personnel, Hollywood stars and entertainers. Most importantly, Jason has helped over 53,000 skinny guys and hard gainers in 126 different countries build muscle and gain weight faster than they every thought possible.
A sedentary lifestyle can lead to having weak and tight hip flexors as they are always in the shortened position. Tight hip flexors can lead to a limited range of motion, poor posture, lower back, and hip pain, and even injuries. These muscles need to get a workout when you are standing and doing movements such as raising your leg to climb stairs, run, or ride a bicycle.
Your questions kinda ties everything together. You are already aware of “nutrient density” which is AWESOME. This is important because I believe one food may be more “healthier” over another due to its “nutrient density”. The other food is still healthy because it still contains nutrients, but the nutrients could be more dense…so this is why I think one food may be “healthier”, while the other just isn’t as “healthy”. It’s not, not healthy.. Make sense?
^ Burd, Nicholas A.; Yang, Yifan; Moore, Daniel R.; Tang, Jason E.; Tarnopolsky, Mark A.; Phillips, Stuart M. (2012). "Greater stimulation of myofibrillar protein synthesis with ingestion of whey protein isolate v. Micellar casein at rest and after resistance exercise in elderly men". British Journal of Nutrition. 108 (6): 958–62. doi:10.1017/S0007114511006271. PMID 22289570.
Most typical bodybuilding programs have way too many sets and reps and use the wrong exercises. However, if you lower the total volume, go heavier, and use compound movements as I’ve outlined above, there is nothing wrong with a body-part split for advanced lifters. In fact, it’s often less stressful to the joints than your average upper/lower split.
The important role of nutrition in building muscle and losing fat means bodybuilders may consume a wide variety of dietary supplements. Various products are used in an attempt to augment muscle size, increase the rate of fat loss, improve joint health, increase natural testosterone production, enhance training performance and prevent potential nutrient deficiencies.
Don’t get us wrong—cardio is important for keeping your body fat down and keeping your heart health in check. (Bonus points if you run or bike, since outdoor exercise is linked to better energy and improved mental health.) But when it comes to building muscle, hitting the treadmill won't help you much. “Every component of exercise, minus cardio, can help with muscle hypertrophy,” which is the scientific term for muscle building, says Michelle Lovitt, an exercise physiologist and trainer in Los Angeles. “Cardio tends to burn calories and puts your body in a deficit, which is great for leaning out, but not building mass.”
Let’s say your concentric is 30lbs and you don’t take my advice and keep the 30lbs for your eccentric. Let’s say, I assume you can do 50lbs on the eccentric, but choose to keep it at 30lbs. If you actually started off making light weight feel heavy, that 30lbs would of been around 10–20lbs and my assumption would of been 30lbs. My first assumption was a heavier weight. Your concentric was a heavier weight. What changed? Why did the overall weight become lighter after making light weight feel heavy?
But as I said earlier, the amount of protein you eat is a secondary concern. Quality comes first, so think "what" before "how much." For me, the "what" is lean and not fried. If you adhere to eating lean, non-fried sources of protein, you maximize your chances of gaining maximum amounts of muscle with minimal increases in body fat. My favorite sources of lean protein are standard: egg whites, chicken breast, 98 percent or leaner ground beef, turkey, fish, and quality protein supplements like Lean Pro8.
Choosing the right size stability ball matters—if you’re using one that’s too big or small, your body positioning could be wonky, making the move less effective, says Henwood. For the V-Lift and Bulgarian Split Squat in this workout, choose a ball that naturally has your legs at a 90-degree angle when you sit on it (your hips should be at the same height as your knees). You may need a smaller option for the Hamstring Press—opt for one that you can comfortably hold between your legs so it stays put for every rep.
This stretch gets at the piriformis muscle of the hip flexor. Sit with both legs extended in front of you. Bend the right knee and place the right foot on the floor. Place your right hand behind you and hook your left elbow on the outside of the right knee. As you twist toward the righthand side, keep your spine straight and breathe deeply. Switch sides after about 20 seconds.
But how do you actually know if you have weak glutes? A good way to test them is to do a single leg squat as low as you can go, says Brian Schulz, MD, an orthopedic surgeon and sports medicine specialist at Kerlan-Jobe Orthopaedic Clinic in Los Angeles, CA. “Knee flexion to 90 degrees is a good sign that the gluteal muscles are strong enough,” he says.
The general strategy adopted by most present-day competitive bodybuilders is to make muscle gains for most of the year (known as the "off-season") and, approximately 12–14 weeks from competition, lose a maximum of body fat (referred to as "cutting") while preserving as much muscular mass as possible. The bulking phase entails remaining in a net positive energy balance (calorie surplus). The amount of a surplus in which a person remains is based on the person's goals, as a bigger surplus and longer bulking phase will create more fat tissue. The surplus of calories relative to one's energy balance will ensure that muscles remain in a state of anabolism.
How to do it: Start by stepping forward into a lunge with your left foot. Place your right forearm to the ground and your left elbow to the inside of your left foot, and hold the stretch for two seconds. Then place your left hand outside of your foot and push your hips up, pointing your front toes up. Return to standing position and repeat by stepping out with your right foot. Continue alternating sides.
After all, if you’re doing more reps in a set, the weight would obviously be lighter and the intensity level lower. If you’re doing fewer reps in a set, the weight is obviously heavier and the intensity is higher. In addition, how close you come to reaching failure – aka the point in a set when you are unable to complete a rep – also plays a role here.
Dips. You should be able to manipulate your bodyweight in space against the influence of gravity. If you can’t perform simple movements such as pushups, dips, and chin-ups then you need to work on your relative strength. That being said, dips are an excellent muscle builder for the chest, triceps, and shoulders if they are progressively overloaded with weight.
Longer rest periods are more ideal for making progressive tension overload happen, and shorter rest periods are more ideal for generating metabolic fatigue. So, if you’re doing an exercise that is better suited for progressive overload (i.e. primary compound exercises), you’re going to want to rest longer between sets to maximize strength output. And if you’re doing an exercise that is better suited for metabolic fatigue (i.e. isolation exercises), you’re going to want to rest less between sets to make that happen. And if you’re doing an exercise that is suited equally for a combination of the two (i.e. secondary compound exercises), you’re usually going to want a moderate rest period somewhere in between.
The spine has a natural curvature in it in order to function correctly. With their attachment on the spine and pelvis, tight hip flexors can cause an unnatural curve of the spine called hyperlordosis. Hyperlordosis affects the way forces are distributed in the spine and can cause pain and soreness in the lower back. Other common problems that are associated with hyperlordosis are weak abdominal muscles, weak hamstrings, tight low back muscles, as well as tight hip flexors. This can lead to hip flexor and groin strains and hamstring strains…..an all around mess!
More specifically, you can expect to end up in the upper half of these ranges ONLY if you are a beginner, younger, and/or have amazing genetics. You can expect to end up in the lower half of these ranges if you are an intermediate or advanced trainee, older, and/or have poor genetics. The average person can expect to end up somewhere in the middle. Additional details here: How Much Muscle Can You Gain?
How to do it: Begin with one foot firmly planted in front of you with your other leg extended back. Keep balance by putting your weight in the ball of your front foot and the back heel of your back foot. Hold a dumbbell in either hand, arms at your sides. Or, place a resistance band under the foot of your working leg, up, and around the same shoulder. Stand tall and bend your front working leg to approximately 90 degrees, keeping your knee directly over your ankle so it doesn’t over-extend. Return to the start position and repeat. Do both sides.
Other muscles that can be recruited to assist with hip flexion include the tensor fascia latae (TFL), the pectineus, the adductors, the gracilis, and the anterior aspects of the gluteus medius and the gluteus minimus. The contribution of these secondary hip flexors largely depends on the position of the hip at the time at which movement is initiated.
You're aiming to kick start muscle hypertrophy, the cellular process that spurs growth. Researchers have found that the best way to initiate that process is by performing two or three sets of an exercise for six to 12 repetitions, with about 30 to 60 seconds' rest between sets. You're damaging the muscles with the work — then the protein you've been consuming will help build them back up even bigger.